laguna MT01002, Руководство пользователя, Страница: 17 / 49

8. With the machine running [no cutter fitted] operate the red stop
switch by pressing towards the machine. The motor should have the
power removed and slow down.
9. With the machine running [no cutter fitted] operate the red emergency
stop switch by pressing towards the machine. The motor should have
the power removed and slow down. To reset the emergency stop
switch either, pull out or rotate clock wise, depending on the type of
switch fitted to the machine. The machine will NOT start with the
emergency switch pressed in.
10. With the machine running, slowly open the access door until the safety
switch cuts the power to the motor. Close the door until the motor has
stopped.
11. Check that the correct speed indicator light is lit for the speed
selected.
12. If the safety switch fails to operate correctly, do not use the machine
until the fault has been corrected.
Before you cut any wood read the safety rules at the front of this manual
Fitting the shaper fence system
1. Fit the steel bar to the
table by aligning the
dowels with the relevant
holes in the table.
2. On the shaper fence
housing, release the
clamp handle located on
the same side as the bar
will be fitted. Lower the
shaper fence system on to
the steel bar and screw
the clamp screws into the
holes in the table [do not
fully tighten].
Clamp
handle
Top clamp handle
Shaper
fence system
Shaper
fence system
16