Laguna Tools MPSP12-5-0135, Руководство пользователя

Страница: 17 / 66

1. Secure a 4" dust hose to the dust port located under
the saw table. (Fig. 38)
2. Run the 4" hose to your dust collection system. Slide the
blade guard/dust hood over the riving knife and
attach it with a M8-1.25 x 40 button head cap screw
and a flat washer (Fig. 39)
3. Secure a 2-1/2" dust hose to the dust port on the top
of the blade guard (Fig. 39)
4.Run the hose over and connect it to the dust
collection system.
5. Run a ground wire along the dust hose and attach the
wire to the machine to protect against static electricity.
(16) Power Cord
1. Open the terminal box (Fig. 40)
2. Feed the power cord thought the strain relief on the
bottom of the control panel and connect the cord to the
terminals. If finish, close the terminal box.
3. Shut off the main power at the power source circuit
breaker and install the cord to the s\disconnect switch.
Fig. 40
(17) Test Run
Before operation, it must be testing this machine to make sure all the controls are working properly.
WARNING
Before starting the saw, make sure you have performed the preceding assembly
and adjustment instructions, and you have read thought the rest of the manual and
are familiar with the various functions and safety issues associated with this machine.
Failure to follow this warning could result in serious personal injury or even death
！
1. Connect the machine to the power source.
2. To check the machine light is turning on.
3. Press the main blade button, if the main blade is rotating in a counter-close wise, then press the
scoring blade button, if the main blade is rotating in a clockwise direction, disconnect the saw from
power and exchange wires in the terminal box.
Operation
You must follow these instructions EVERY time you use your saw.
1. Stand to the left of the blade line-of-cut when performing a cutting operation.
2. Turn off the saw and allow the blade to come to a complete stop before removing the cut-off piece.
3. Make sure the riving knife is always aligned with the main blade before cutting.
4. Always position the blade guard to the correct height above the workpiece.
5. Carefully plan each cutting operation to avoid injuries.
6. When you lease the sliding table lock, make sure that the knob is positioned so that it will not lock the
table during a cut.
15
Vertical