Laguna Tools MPSP12-5-0135, Руководство пользователя

Страница: 22 / 66

Crosscutting using rip fence as a cut-off gauge
1. Install the crosscut fence in the rear mounting
points (Fig. 58) and lock it in place.
2. Position the rip fence for the desired width.
3. Load the workpiece onto the table saw.
4. Slide the leading end of the rip fence behind
the back edge of the blade. (Fig. 58)
5. Take all the necessary safety precautions,
Fig. 64
then perform the cutting operation.
(6) Miter Cutting
The miter fence allows miter cuts from 0° through 135°.
The table mounted miter scale has a resolution of 1°.
1. Slide the crosscut table to the front edge of the sliding
table and lock it in place.
2. Place the crosscut fence center stud in the center stud
hole of the crosscut table. The fence can be installed
for 90° to 135° cuts (Fig. 59), or 0° to 90° cut.
3. Rotate the fence to the desired angle and use lock knob
to lock the fence in place.
4. Position the flip stop according to the length of the
workpiece you want to cut off to the left of the blade.
5. Load the workpiece onto the table saw.
6. Once all the necessary safety precautions have been
taken, perform the cutting operation.
(7) Lubrication
Lubrication the areas indicated below every 6-12 months,
depending on frequency of use.
1. Blade angling trunnion.
2. Sliding table ways.
3. Scoring blade worm gear
4. Blade height linkage.
5. Blade height bearing
6. Blade tilt worm gear
7. Blade height slide
Fig. 64
20
90
°
tilt stop hex nut
Lubricate
Fig.58
Fig. 60
Vertical