Trading Table Saw Cutting
1. Slide the crosscut table out of the way.
2. Lock the sliding table into a stationary position. (Fig. 49)
Fig. 49
3. Place the fence in the vertical position (Fig. 50)
for larger workpiece, or in the horizontal position (Fig. 51)
for angled cuts and for small workpiece.
4. Slide the leading end of the rip fence so it is even with the
center of the main saw blade (Fig. 52)
Note
:
This technique allows the finished cut-off piece to
"fall" away from the blade when the cutting operation is complete,
reducing the possibility of kickback.
5. Life the lock lever and position the rip fence to
approximately the desired width-of-cut.
6. Tighten down the micro-adjust lock knob (Fig. 53)
and turn the micro-adjust lock to zero in on the desired
width-of-cut.
7. Push down the lock lever, then perform the cutting operation.
Fig. 53
18
Fig. 50
table
Horizontal
Vertical
Vertical
Fig. 51
Содержание MPSP12-5-0135
