Lagler Trio, Эксплуатация Обслуживание Безопасность

Страница: 9 / 52

9
This paragraph contains instructions on how to put your TRIO ma-
chine into operation at the workplace. In order to prevent damage
and malfunctions it is necessary to strictly stick to the sequence
of steps indicated below.
Before you start your first job with TRIO you have to receive in-
struction.
3.1 PREPARING THE MACHINE
1 Unpack the machine carefully. Take care to deposit the pack-
aging materials that are no longer required in an environmen-
tally-friendly way.
To ensure safe dispatch of the machine, the packaging should
be used for transport purposes.
2 After unpacking the machine, release the securing grip of the
handle, press handle forward and pull, securing grip back into
its prior position (Fig. 2).
3 While holding on to the handle, carefully tilt the machine back-
wards into a horizontal position. Make sure that the machine
gets to rest safely on the guide tube and the two protective
cushions. Now the sanding gear is accessible from the front
(Fig. 3). Make sure the machine is in a safe position!
4 Mount the gear of your choice by placing one of the three
locking bolts into the rubber jig and then fitting the other two
bolts into their respective jigs. Then press gear onto the bear-
ing as far as it will go (Fig. 4).
5 Bring the machine back into vertical position so that the
sanding gear is resting flat on floor surface. Adjust the handle
height to your convenience.
6 Open the dust bag box by turning the two fasteners upwards;
open up the movable half of the dust bag box.
GETTING STARTED
Getting started
Fig. 2 To tilt the machine, release the clamping lever of
the handle first and press the handle forward.
Fig. 3 Carefully tilt the machine backwards to be able
to access the gears.
Make sure the machine is
in a safe position!
Fig. 4 Place one of the three bolts one of the jigs, fit
others into their respective jigs, press the gear
onto the bearing as far as it will go.
3
ATTENTION!
Make sure the gear is in place correctly. It must slide in place
with a perceptible click. Always use three gears of the same
type!