Lagler Trio, Эксплуатация Обслуживание Безопасность

Страница: 16 / 52

16
TRANSPORT AND STORAGE
Transport and storage
5.1 DISMANTLING THE MACHINE
For transport purposes the machine can be dismantled into two
pieces: chassis (frame with wheels, guide tube and dust separator)
and sanding unit (machine casing with motor and sanding gears).
Please make sure that sanding unit remains in an upright position
during transport. It is necessary for the motor to stand vertically
on top of the gear casing.
All parts of the machine must be secured during transport in the
truck or similar in such a way that they can not move or topple over.
When manually transporting the TRIO over roads and paths use LÄ-
GLER’s TransCart to protect the gear and wheels against damage.
The TRIO three disc sanding machine is dismantled as follows,
please stick precisely to the suggested sequence of steps:
1 Switch the machine off.
2 Remove the plug from the socket!
3 Loosen the cable plug of the sensor on the on/off switch by
turning the ring nut; pull out plug (Fig. 18).
4 Remove the on/off switch from the chassis and hook it into
transport support on motor switchbox (Fig. 19).
5 Remove the dust suction hose from the neck of the dust sepa-
rator or the neck of gear casing.
6 Loosen the two lateral crossnut fasteners on the casing and
roll the chassis backwards in an upright position (Fig. 20).
Fig. 19 Hook the on/off switch into the transport support
on the motor switchbox.
Fig. 20 The chassis can be moved backwards once the
crossnut fasteners have been loosened.
Fig. 18 Loose the ring nut and remove the plug from the
mains.
5