Lagler Trio, Эксплуатация Обслуживание Безопасность

Страница: 23 / 52

23
MAINTENANCE WORK AND REPLACEMENT OF WEARING PARTS
Fig. 37 Turn the counter nut back to the casing wall.
Fig. 38 Turn the clamping nut back to the counter nut.
Fig. 39 Push the tooth belt tensioner back and remove
the tooth belt.
3 Now tighten the spring using the nuts, whereby the spring
must be tightened to the following length:
Tightened length X of the spring (Fig. 42)
- Orange spring: 55 mm (approx. 2 1/8“)
- Blue spring: 52 mm (approx. 2“).
Carefully fasten the counter nuts.
4 Replace the cover and fix it in place using the eight screws.
5 Mount the gear of your choice by placing one of the three
locking bolts into the rubber jig and then fitting the other two
bolts into their respective jigs. Then press gear onto the bear-
ing as far as it will go.
6 Tilt the machine back into the vertical position and adjust the
handle height to your convenience.
Fig. 40 With the tensioner pulled back, insert the tooth
belt with the geared side facing and engaging the
pinion gearing with the flat side of belt skirting the
gear bearings.
Fig. 41 When the tooth belt tensioner is at the bottom,
place the belt loop around the pinion from the
left.
Fig. 42 The length X of the tightened spring is:
- Orange spring: 55 mm (approx. 2 1/8“)
- Blue spring: 52 mm (approx. 2“).
6