Lagler Trio, Эксплуатация Обслуживание Безопасность

Страница: 31 / 52

31
TROUBLESHOOTING
• Voltage too low: check quality and length of the cable. Avoid
cable cross-sections which are too small (wire cross-sections
smaller than 2.5 mm²) and cables which are too long. Use a
booster if necessary (order no. 708.00.00.100 for 230 V).
• Check the tension of the tooth belt and V-belt and correct if
necessary.
• Check that the drive unit is running freely.
• An incorrect or blunt sanding agent is being used.
Machine vibrates strongly and is works loudly
• Check that all three sanding gears are fitted absolutely identi-
cally.
• Check for correct sanding gear fit.
• Check the sanding agents for damage.
• Check whether the sanding agents are fastened in the center
of the sanding disc.
• Check the flexible base between the sanding disc and the
sanding agent for damage.
• Check tension on V-belt and tooth belt, replace the belts if
necessary.
• Check the machine for clogging and deposits of dust or debris,
clean if necessary.
• Check the crossnut fasteners, tighten if necessary.
THE MACHINE IS RUNNING BUT THERE IS NO DUST PICKUP
LED on the pressure control sensor is lit
• Clean filter.
• Disposable dust bag is full and must be replaced.
LED on the pressure control sensor is still lit
• Check whether dust system is blocked, clean.
• Have the filter checked, replace it if necessary.
• Have the sensor checked. Use a soft brush for cleaning ( never
compressed air! ).
• Check the sealing felt on the sanding gear cover, replace if
necessary.
8