Lagler Trio, Эксплуатация Обслуживание Безопасность

Страница: 12 / 52

12
WORKING WITH THE TRIO
4.2 CHANGING SANDING GEAR
Depending on the different types of work to be done you may have
to change the sanding gear. To do this, proceed as follows:
1 Switch the machine off.
2 Disconnect power supply before commencing any work on
the machine; this will prevent inadvertent motor action!
3 Release clamping lever of the handle, press handle for-
ward and pull the clamping lever back into its prior position
(Fig. 5).
4 While holding on to the handle, carefully tilt the machine back-
wards into a horizontal position. Make sure that the machine
gets to rest safely on the guide tube and the two protective
cushions (Fig. 6). Make sure the machine is in a safe posi-
tion!
5 To remove gear, grasp its edges with your fingers and pull it
out of the rubber jigs of the bearing (Fig. 7).
Never use a screwdriver or a chisel for this job as this could
otherwise cause damage to the discs or the machine.
6 Mount the gear of your choice by placing one of the three
locking bolts into rubber jig and then fitting the other two bolts
into their respective jigs. Then press gear onto the bearing as
far as it will go (Fig. 8).
7 Bring the machine back into vertical position so that the
sanding gear is resting flat on floor surface. Adjust the handle
height to your convenience.
Fig. 7 Grasp the gear edges with your fingers and pull
it out of the rubber jigs.
Fig. 5 To tilt the machine, release the clamping lever
first and press the handle forward.
Fig. 6 Tilt the machine backwards so that you can ac-
cess the gears.
Make sure the machine is in a
safe position!
Fig. 8 Place one of the three bolts into the hole of one
jig, fit the others respectively and press the gear
on as far as it will go.
4
ATTENTION!
The gear must fit tightly on the bearing and slide into place with
a perceptible click. Always use three gears of the same type!