Lafayette Auto-Lift Parasol Cellular Shades, Руководство по установке

Страница: 14 / 22

INSTALLATION
12
STEP 3 — Connect the Power Source
■
Refer to the appropriate page based on your order.
➤
For a battery wand or satellite battery pack, see “If You Have a Battery Wand or Satellite
Battery Pack...” below.
➤
For an optional DC power supply, see “If You Have a DC Power Supply...” on page 14.
➤
For an optional DC power supply with daisy-chain connections, see “If You Have a DC
Power Supply with Daisy-Chain Connections...” on page 14.
If You Have a Battery Wand or Satellite Battery Pack...
Install the Batteries into the Battery Wand
■
Squeeze the cap latch to release the cap.
■
Remove the cap from the battery wand.
■
Install the batteries according to the
instructions on the battery wand label.
➤
AA alkaline batteries are recommended for use with Battery-Powered shades. These will
provide approximately one year of operation. Lithium and rechargeable batteries are not
recommended.
■
Replace the cap.
➤
Align the tab with the end of the wand.
➤
Press the cap on until it latches.
IMPORTANT: If you have a satellite battery pack, proceed to “If You Have a Satellite
Battery Pack...” on page 13 for installation of the wall mount bracket.
Mount the Battery Wand into the Battery Wand Clip
■
Align the battery
wand with its socket
toward the motor
side end cap.
■
Push the battery
wand straight up into the
battery wand clip until it snaps into place.
Check to make sure the battery wand is secure.
CAUTION: Be sure the cable does not become pinched by the battery wand clip during
installation. Damage or overheating of components could result.
Tab Slot
Cap
Latch
Battery
Wand
Squeeze
Back of Shade
Socket