Chapter 4 - Testing Your Blood Glucose Level
step Two - removing the Glucose Meter From the housing
33
y
Only use a lancet authorized by LabStyle Innovation™ (
30G)
.
y
If the lancet does not click into place or the lancet holder does not
hold the lancet properly, insert another sterile lancet.
y
If the problem persists, it may be necessary to replace your Dario™
housing. Contact Customer Support at
www.mydario.com
.
5.
Carefully twist off the lancet cap as shown above. Make sure not to bend the
lancet needle.
6.
If necessary, set the depth of the lancing device. For additional information, see
Setting Lancet Depth (Optional) on page 12
.
7.
Replace the lancing device cover by sliding it into place until it clicks. Be careful
not to touch or bend the lancet.
sTeP TWo - reMovinG The GLuCose MeTer FroM The
housinG
Before starting the testing procedure, you should remove the meter from the
housing.
The meter is stored in the housing when not in use.
To remove the meter from the housing:
1.
Hold the housing so that the ridged orange panel is close to you and the end
with the lancing device is facing away from you.
2.
Slide your thumb back on the ridged orange panel.
The meter will pop up.
