Labrie EXPERT 2000 2002, Руководство оператора

Страница: 66 / 69

EXPERT 2000
66
DANGER
WARNING
3.6.5 TROUBLESHOOTING QUICK
REFERENCE
If an electrical failure occurs and prevent the
operator from retracting the arm, the following
procedure can be applied.
a) Apply the parking brake and put the
transmission in neutral.
b) Contact the service center.
c) The following precedure may be applied
by the maintenance personnel to manually
retract the arm.
The operator alone must
not try to apply this procedure.
STAY OUT OF THE PATH OF
THE ARM OPERATING RANGE
WHILE MANUALLY MOVING
THE ARM. SERIOUS INJURY OR
DEATH MAY RESULT.
NEVER DRIVE THE VEHICLE IF
THE AUTOMATED ARM IS NOT
F U L L Y R E T R A C T E D I N I T S
RESTING POSITION. (THE RED
L I G H T
C O M E S O N I F
A U T O M A T E D A R M I S
EXTENDED.) SINCE THE UNIT
MAY BE TOO HIGH AND/OR
WIDE, FAILURE TO DO SO MAY
R E S U L T I N U N I T A N D / O R
P R O P E R T Y
D A M A G E S ,
PERSONAL INJURY OR DEATH.
FLOW DIVIDER
MANUAL OVERRIDE
• Remove the solenoid valve
connector on the flow divider (figure
#3.51).
• With a power supply or battery, feed
the coil with 12 volts DC on pin 1
and 2 (figure #3.52). At this time the
flow divider SHOULD engage itself
and give hydraulic power to the
proportional valve. The arm can now
work manually with the levers on
the proportional valve (figure #3.53).
• In the case when a roller cart is
stuck in the grabber, bring down
the cart to release it. Retract the
arm and the grabber inside the
hopper.
• Close the hopper door and drive the
vehicle to the maintenance facility
for repair.
FIGURE #3.51
CONNECTOR
FLOW
DIVIDER