Labrie EXPERT 2000 2002, Руководство оператора

Страница: 49 / 69

49
OPERATOR’S MANUAL
WARNING
3.4.14 PACK ON THE GO
It may be useful to expedite your work and be
more efficient to
“ pack on the go ” . As you are
finished with loading the hopper and instead
of standing beside the truck as you are cycling
the ram, you can get in the cab and activate the
ram cycle from there. The hydraulic pump will
turn at the engine RPM depending on the truck
speed, and will allow the ram to cycle even
when you are moving to your next pick up.
This procedure is quite practical when it is
time to
“ break the load ” , allowing you to get
more cycle on the refuse, as you go along.
3.4.15 STANDARD UNLOADING PROCEDURE
Once you have finished your route lower the
crusher panel (if the option is installed) and
close the hopper doors on both sides. Ensure
that you have some garbage not compacted in
front of the packing blade to help you in the
“ unloading procedure ” .
STANDARD UNLOADING
PROCEDURE
• Drive the vehicle to the desired site.
• Ensure the vehicle is on safe stable
and level ground;
• Check for overhead clearance
before opening tailgate and raising
body;
• Remove tailgate safety pins;
• Fully raise the tailgate;
• Raise the body, the material should
slide out (As you raise the body you
can accelerate the engine to get it
completely up faster. Do not
accelerate the engine for the last
section of the hoist to prevent a
sharp stop at the end of the cylinder
extension.);
• Move the vehicle forward to prevent
the garbage from piling up under
the tailgate door (This is the only
time you can move the truck with
the body in the raised position, do it
very cautiously and cover the
shortest distance possible.);
• Cycle the packer blade to help eject
the garbage that could be caught in
the slope. (It may help to have some
garbage in the hopper to enhance
the effect of the packer blade cycle);
• Lower the body and close the
tailgate if the body has been
adequately emptied;
• Put the safety pin back in place
(Figure #3.28);
• Drive away from the unloading site
(See section 3.4.18 about daily
cleaning of hopper).
NEVER RAISE THE BODY IF THE
TAILGATE IS NOT OPEN (THE ICC
BUMPER WILL NOT CLEAR THE
GROUND)