Labounty MRX Series, Безопасность, эксплуатация и обслуживание

Страница: 26 / 36

26 | MRX Multi-kit Demolition Tool Operation & Maintenance Manual
Guide Blade Rotation
Each guide blade has two edges. Rotate the blade when the cutting edge is worn to a .25” radius. Replace when
both edges are worn.
1. Remove the blade bolts and remove the blade from the blade seat.
2. Ensure the blade seat is clean.
3. Rotate the blade end-over end or install a new blade.
4. Insert the blade bolts and torque as specified in “Inspect / Torque Bolts” on page 23.
Cross Blade Rotation
1. Remove the cross blade.
2. Rotate it end-over-end
3. Re-install the cross blade. Torque bolts as specified in “Inspect / Torque Bolts” on page 23.
4. Check the blade gap. Shim if necessary.
Note: The guide blade can only be rotated once. Replace during the next rotation.
Tip Blade Rotation
The tip blades cannot be shimmed or rotated. Once worn, the blade must be replaced.
1. Loosen the blade tip bolts.
2. Remove the blade.
3. Clean the blade seat.
4. Install a new tip blade and replace the blade bolts. Torque as specified in “Inspect / Torque Bolts” on page 23.
TOOTH MAINTENANCE
When the jaw teeth are worn or cracking, performance is decreased and the teeth need to be replaced.
Wear personal protection equipment at all times. This
includes eye protection, hard hat, steel toe shoes,
leather gloves and hearing protection.
Jaw teeth are very heavy. DO NOT remove a tooth pin if
the tooth is not supported. The tooth may fall and cause
injury.
1. Locate flat, hard ground and place the attachment on the ground.
Note: Work only on the jaw closest to the ground, with the tooth facing up.
2. Remove the bolt and nut that holds the tooth in the jaw.
3. Remove the tooth from the receptacle.
4. Insert a new tooth into the receptacle.
5. Insert bolt and fasten the nut to secure the tooth. Torque as specified in
“Inspect / Torque Bolts” on page 23.