10
eVO 350
SETUP (continued)
8126300-795
eVO 350
Issue 1.2
Printed on June,2020
UNPACKING AND INSTALLATION (continued)
7. Open the box marked as ‘’Microscope Assembly’ ’.
Remove the Microscope Assembly, Slit lamp
Assembly, Power Supply and Accessories. Refer to
Figure-5.
8. Install the Slit Lamp Assembly onto the tracks of
the Table Top and slide the Guide Rail Covers
around the tracks. Refer to Figure - 5.
9. Assemble the power supply bracket to the table
top using (2) M4 Allen screws provided with
it. Referred as (B) in fig.6 .
10. Assemble Power Supply to the table top just by
pushing into the hole shown as (C), refer fig. 7 .
11. Connect the power supply earthing wire with
t
a
b
l
e
top at point “D” using 3 mm Allen wrench. Refer
fig. 7 a.
12. Attach the Base Lamp Wire Connector to the back
of the Power Supply Assembly. Refer to Figure - 8.
13. Connect the Chinrest target light connector to
the Power Supply Assembly by plugging it in. Refer
to Figure 8.
14. Using the 4mm Hex Wrench, adjust the Patient
Handles by loosening the Allen Cap screws that are
securing them to the Chinrest Posts. Slide the
Patient Handles up or down to the desired height,
and secure them in place by tightening the Allen
Cap Screws. Refer to Figure - 9.
Figure- 4 Microscope, Base, Power Supply
& Accessories
Accessories
Power
Supply
Microscope
Slit lamp Base
Slide
Figure- 5 Install Base
Figure- 7 Assembling Power Supply on the
Power Supply Bracket
C
D
Figure- 9a. Earthing wire attaching screw
Figure- 8 Connections
Chin Rest
Target
light
Connector
Base Lamp
Wire
Connector
Figure- 9 Adjusting Patient
Handle Height
Move
Handles
Up/Down
Allen Cap
Screws
Figure-6 Chin Rest Ground
B
