LM-3605 Dynamic Label Applicator
USERS MANUAL
Page 29
Made in the U.S.A.
© 2019 LABELMILL
12/01/2019 Model LM3605
PROGRAMMING
All programming is performed via the
HLI-100
keypad and display as shown on page 2-6. All programmed settings
are backed in nonvolatile memory and are not lost when the unit is powered off.
Upon power up of the control, the screen will display
MODEL NUMBER & REVISION
of the HLI-100 and then the
MODEL NUMBER & REVISION
of the labeler control
.
After this, the screen will now display the counter,
TOTAL
XXXXXXX
.
•
KEY FUNCTIONS:
“PROG”
PROGRAM KEY IS USED TO:
1.
Enter and exit
the program menu.
“ENTER”
KEY IS USED TO:
1. Access or “Enter” the selected “PROGRAM BLOCK”. (example PRODUCT SENSOR or TAMP SETUP)
2. Access or “Enter” the
data selection/options
line (bottom line of display) of the “PROGRAM BLOCK”
Sub Menus.
3. Store the selected data.
UP / DOWN ARROW
KEYS ARE USED TO:
1. Scroll up & down through the primary menu “PROGRAM BLOCKS” . (Header name)
2. Scroll
sub menus
inside of “PROGRAM BLOCKS”. (top line of display while
IN
a “PROGRAM BLOCKS”)
3. Increment and decrement programmable values.
4. Select different display views while in the “RUN” mode.
Left / Right
ARROW
KEYS ARE USED TO:
1. Move the “up carrot” left or right when programming a value.
START / ENABLE
KEY:
1. Start key will initialize the application cycle.
2. Enable key will “Enable” the drive after it has been disabled.
CLEAR / STOP
KEY:
1. Stop key will abort the cycle only when not in the program menu.
2. Clear key will delete stored values while in the edit mode.
3. Clear key will disable the drive.
ESC (escape)
KEY:
1. Will back out of the sub programming menu without saving changes.
3-01
