user manual
Flashline
Flashline User Manual
page 28
• Release the drop links on cabinet #4 from their stowed positions by removing the bottom front and rear pins and
allowing the drop links to drop down to their extended position. Replace the pins in the front andf rear positions.
• Lower the cluster very slowly, allowing the drop links on cabinet #4 to locate into the channels of the flying
hardware on cabinet #5, eventually sitting flat on top of it.
#4
#5
#6
#3
• Locate the top rear pins on cabinet #5 in the
LOCK/GRID
position. Set the angles on cabinets #5, #6, #7 and #8
using the top front pins if these have not been done already. Take both motors up together and lift the second
block of cabinets off the TFS-DOLLY. As before the fronts of the cabinets will now open up depending on the
angles set between them.
• Fit the remaining lock pins to stabilise the array.
• Continue this procedure until the required number of cabinets are flown.
• Raise the array to the height specified by your EASE Focus2 prediction using a tape measure or laser system to
check the height of the array
