Laars Mini-Therm JVi JVH, Инструкция по установке и эксплуатации

Страница: 17 / 28

Mini-Therm JVi
Page 17
• Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions. If you cannot reach your gas supplier,
call the fire department.
C. Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob will not
push in or turn by hand, don’t try to repair it. Call
a qualified technician. Force or attempted repair
may result in a fire or explosion.
D. Do not use this boiler if any part has been under
water. Immediately call a qualified service techni-
cian to inspect the boiler and to replace any part of
the control system and any gas control which has
been under water.
FOR YOUR SAFETY, READ BEFORE OPERATING
WARNING
If you do not follow these instructions exactly, a fire or explosion may result causing property damage,
personal injury, or loss of life.
A. This boiler is equipped with an ignition device
that automatically lights the pilot. Follow
operating instructions, do not try to light the pilot
by hand.
B. BEFORE OPERATING, smell all around the
boiler area for gas. Be sure to smell next to the
floor because some gas is heavier than air and will
settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any
phone in your building.
1. STOP! Read the safety information above, on this
page.
2. Set the thermostat to the lowest setting.
3. Turn off all electric power to the boiler.
4. This boiler is equipped with an ignition device
which automatically lights the pilot. Do not try to
light the pilot by hand.
5. Set ignition control switch to "OFF." Turn the gas
control knob (clockwise for JVP) to the full
“OFF” position.
6. Wait five (5) minutes to clear out any gas. Then
smell for gas, including near the floor. If you
smell gas STOP! Follow “B” in the safety infor-
mation above. If you don’t smell gas, go to the
next step.
7. Set ignition control switch to “ON.” Turn the gas
control knob (counterclockwise for JVP) to “ON”.
8. Turn on all electric power to the boiler.
9. Set thermostat to desired setting.
10. If the boiler will not operate, follow the instruc-
tions TO TURN OFF GAS TO BOILER and call
your service technician or gas supplier.
OPERATING INSTRUCTIONS
Pressure Regulator
Adjustment Screw Gas Control Knob
(Shown in “ON” Position)
Gas
Inlet
Gas Outlet
Honeywell SV9501/9601
Honeywell VR8304