S1 Dream-T Espresso Machine
Owner’s Manual
Page 6
Power Modes
The S1 Dream-T can be set up to work in full power mode. In full power mode the machine
draws 20amps of power so a 20 amp receptacle and breaker must be used. If one is not
available then full power mode MUST be turned off.
In full power mode the machine is able to heat both boilers at the same time. This is helpful if
you want to be able to pull a shot and steam milk at the same time.
When full power mode is turned off then it is only able to heat one boiler at a time and will
always give priority to the coffee boiler. In this mode it is recommended to pull a shot and
steam milk separately or the machine may lose steam pressure if done at the same time.
The power mode can be easily changed in the “Factory” menu.
The password for the factory menu is
J73MZ
Note: In version 1.19 the Factory menu has been removed and the full power mode can be
accessed without a password.
Warning: Using the machine in full power mode in a 15 amp outlet should never be done.
Failure to follow this warning could pose a fire hazard and is not recommended.
Information Center
With the machine turned on, press and hold the up arrow key. The display
will then show the serial # and current firmware version. Then press the down arrow key to
cycle through the machine settings and alarms. To exit out of the information screen press the
ok/menu button.
Features
User Profiles
The S1 Dream-T is capable of storing 4 different user profiles. This enables the machine to be
programmed for different shot volumes, brew temperature, steam boiler water temperature,
and hot water delivery method. The machine can easily be switched between different user
profiles to meet the discriminating demands of everyone that uses it. Profiles can also be used
for different coffee blends that require different temperatures so use your imagination and the
possibilities are endless.
Creating User Profiles
