S1 Dream-T Espresso Machine
Owner’s Manual
Page 10
EGS
When enabled the system will release a small amount of water from the grouphead after
20 minutes of inactivity. This is more for the European market where they keep ground coffee
in the portafilter and the EGS system will keep it from drying out. It can also be enabled to help
keep the shower screens clean after pulling a shot.
Auto Shutdown
When enabled the machine will automatically turn itself off after a pre-set
period of inactivity.
Group Cleaning
Allows the user to backflush the machine without being stored in the counter
menu. This is helpful if you are trying to keep track of how many shots are made on the
machine and do not want the backflushing to be counted as a shot.
Screensaver
The screensaver can be turned on or off. When turned on choose between The
Coliseum and the Statue Of Liberty screensavers.
Time Update
Choose to have daylight savings time activated.
Contrast
Change the contrast setting of the display.
Deact Pres Sens
Allows the user to deactivate the pressure sensor for the pump pressure
shown on the display. This is only for plumbed in models.
Password
Allows the user to create a password to block access to the main menu. The default
password is
1-2-3-4
. To change a password select modify. After changing the password then it
must be activated in the password menu. If you forget the password then when prompted to
enter the password press and hold the
button for 5 seconds. The password will be changed
back to default and turned off.
SW Update
Allows the user to update the firmware in their machine. Check our website for
future updates and improvements.
Features
Default Settings
Restores the machine to its original factory settings.
Factory
Allows access to advanced settings. Password
J73MZ
(See Note Below)
Set Calibrate T
Calibration of the temperature sensor. Should only be performed by a factory
trained espresso repair shop.
Full Power
The S1 Dream-T can be set up to work in full power mode. In full power mode the
machine draws 20amps of power so a 20 amp receptacle and breaker must be used. If one is
not available then full power mode MUST be turned off.
