La Marzocco Linea PB, Руководство по эксплуатации

Страница: 15 / 64

EN
14
1/2 a litre of water inside a heat-resistant
container and boil.
- Place the diffuser screen(s) and diffuser
screw(s) in the solution and leave them
fully submerged for about 30 minutes.
Rinse thoroughly with clean water. Install
and run hot water through each group
several times with the screen installed.
IMPORTANT
If the machine has not been used for more
than 8 hours or, in any case, after long periods
of being idle, in order to use the machine to its
full potential it is necessary to perform some
cleaning cycles before brewing beverages as
follows:
- Groups: with the portafilters engaged in
the groups brew water through each for at
least two minutes
- Being careful to avoid burns, turn on each
steam wand for at least one minute.
- Turn on the hot water valve for the time
necessary to allow the following quantities of
water to be brewed:
At least 1 liter for a 1/2 group machine
At least 2 liters for a 3 group machine
At least 3 liters for a 4 group machine
If the machine is not going to be used for long
periods of time, it is advisable to follow
these safety indications:
- Disconnect the machine from the water
mains or interrupt the water connection via a
mains tap.
- Disconnect the machine from the
electrical mains.
WARNING
IN ORDER TO PREVENT CRACKS OR LEAK-
AGE: DO NOT STORE OR INSTALL THE
COFFEE MACHINE IN PLACES WHERE TEM-
PERATURE MAY CAUSE WATER IN BOILER OR
HYDRAULIC SYSTEM TO FREEZE.
WARNING
IF THE ABOVE-MENTIONED INSTRUCTIONS
ARE NOT ADHERED TO THE MANUFACTUR-
ER CANNOT BE HELD RESPONSIBLE FOR
DAMAGE TO PERSONS OR THINGS.
Group
Assembly
Diffusor
Screen
Diffusor
Screw