La Germania LUEP51-90-S, Инструкция пользователя

Страница: 30 / 35

7
than 600mm, or an overhead exhaust fan, 750 mm.
Side clearances to vertical surface:-
If the distance measured from the periphery of the nearest burner
to any vertical combustible surface, is less than 200 mm, the
surface shall be protected in accordance with clause 5.12.1.1
and 5.12.1.2 of AS 5601.
Make sure the minimum clearances to combustible materials are
maintained during the installation including adequate space for
the operation and servicing of the cooker.
Overall dimensions (with legs adjusted to 180mm)
Height over hob: 910 mm
Height over upstand: 980 mm
Height over lid: 1510 mm
Width: 895 mm
Depth: (incl. oven door
handle & knobs):
655 mm
Depth: (flush with oven door): 610 mm
Note:
For stainless steel cookers fitted with an upstand an optional
glass lid is available. Part no: LL01-90-S.
For height limitations use dimensions with lid as shown in
drawing.
30
To replace electronic control box
Follow procedure described as per the heading ‘Access to under
hob area’.
1. The electronic control box is clamped to the RHS burner
support bracket.
2. Unplug the electronic connectors. Mark the connectors to
replace them in the correct order.
3. Push the spring clips together to remove the box.
4. Replace the box by pushing the spring clips into position
and reconnect the electronic connectors in the right order.
5. Reassemble in reverse order.
To replace a cooktop burner electronic spark electrode
Follow procedure described as per the heading ‘Access to under
hob area’.
1. Using an 8mm spanner undo the retaining nut on the
thermocouple.
2. Undo connector to gas control valve.
3. Replace the electronic spark electrode.
4. Reassemble the cooker in the reverse order.
To replace the under hob cooling fan
Follow procedure described as per the heading ‘Access to under
hob area’.
1. Remove cooker rear cover by undoing 7 screws.
2. Remove electric connections to the fan motor.
3. Remove 2 phillips head screws securing the fan to the
ventilation slot.
4. Loosen burner support assembly as per heading ‘To remove
gas control valves and manifold’.
5. Disconnect wiring to oven lamp.
6. Remove the 2 phillips head screws securing the burner
compartment base plate.
7. Lift burner support assembly and loosen slightly the 4
countersunk head retaining screws at the front of the burner
compartment and slide plate back 5mm to clear the 4 locating
slots.
8. Lift the base plate at rear and remove the 3 phillips head
screws from underneath securing the fan assembly to the
base plate.
9. Replace fan and reassemble in reverse order.