5. Setting
up
Setting up using batteries:
First, choose to use the adaptor (included in this set) or
batteries for operation. Both these methods allow for
operation using wireless 433MHz transmission or cable
connection between the base station and the sensors and
setting up for both methods is as follows:
Base Station:
Important:
To avoid operating problems, please take note of
battery polarity if inserting any batteries
1) Pull away the rain cover of the thermo-hygro sensor to reveal the
three sockets (for the wind sensor, rain sensor and the base
station)
2) Connect the attached cables of wind and rain sensors to the
corresponding sockets of the thermo-hygro sensor by clicking
them into place
3) Open the battery cover of the thermo-hygro sensor located below
the three sockets and insert 2 x AA, IEC LR6, 1.5V batteries and
close the cover
4) Open the base station’s battery cover located at the back of the
unit and insert 3 x AA, IEC LR6, 1.5V batteries into the battery
compartment and close the battery cover
Sensor sockets
Battery compartment
Socket for
Thermo-Hygro
Sensor
Socket for
Adaptor
PC COM
Port
Thermo-Hygro Sensor
Battery Cover
Battery
Compartment
Sensor sockets