8
Installation and Assembly Instructions
ASSEMBLY
TOOLS REQUIRED
CP075EK
- Medium Phillips screwdriver.
1.
on the upper housing.
2. Remove the pre-assembled screws on the shell upper and side cover.
3. Align the holes in upper housing with two mounting holes on the handle as shown in Figure 4.
4. Secure handle with screws removed.
5. Insert cord wrap into the rectangle holes on the supporter and align the hole on the cord wrap with
the mounting hole on the side covers shown in Figure 4.
6. Secure cord wrap with screws removed.
CP125FK/CP175FK/CP210FK
- Medium Phillips screwdriver.
- M5 open, or adjustable wrench.
1. Slide threaded axle through the rear section of the wheel support frame.
2. Slide one axle bushing on to each side of the axle. Slide one wheel on to each side of the axle.
3. Attach one cap nut on to each side of the threaded axle and tighten well.
4. Place heater on wheel support frame. Make sure the air inlet end (rear) of heater is over wheels. Align the holes on fuel
5.
6. Align the hole on the handle (front and rear) with the mounting hole on the cord wrap.
7.
8.
Handle
Cord Wraps
Cord Wraps
Wheels
Screws
Screw
Screw
Side Cover
Cord Wrap
Upper Shell
Slit Hole
Wedged Portion
Front Guard
Front
Handle
Rear
Handle
Wheel Support Frame
Axle
Handle
Remove Screws
Remove Screws
Nuts
Flange Screws
Cap Nuts S
Cap Nuts L
Bushings
Figure 4 - Handle and Cord Wrap Installation CP075EK
Model
CP075EK
CP125FK
CP175FK
CP210FK
Wheel Support Frame
No
Yes
Yes
Yes
Wheels
No
Yes
Yes
Yes
Front-Handle
No
Yes
Yes
Yes
Rear-Handle
No
Yes
Yes
Yes
Axle
No
Yes
Yes
Yes
Cord Wrap
Yes
Yes
Yes
Yes
Hardware Kit
No
Yes
Yes
Yes
Handle
Yes
No
No
No
WARNING
Fire or explosion hazard!
- Do not operate heater without support
frame fully assembled to tank.
CP075EK Model
CP125FK/CP175FK/CP210FK Models