KYOWA EDS-400A, Инструкция по эксплуатации

Страница: 18 / 40

15
R05-PB5M
Bridge box
Optional accessory
Strain gage
3-2 CONNECTING INPUT CONNECTORS
The manufacturers and applicable types of input connectors are as follows:
EDS-400A (or EDS-450A) side connector Type: R05-R5F Manufacturer: Tajimi Electronics
Cable connector Type: R05-PB5M Manufacturer Tajimi Electronics
3-2-1 Inputting Strain
Use a 4-conductor shielded cable to connect a strain-gage transducer or strain-gage bridge according to
the pin numbers listed below.
(Cable colors conform to the representative color-coding system applied to Kyowa transducers.)
Pin No. Description of signal
A Positive side of bridge power supply (red lead wire)
B Negative side of bridge output (white lead wire)
C Negative side of bridge power supply (black lead wire)
D Positive side of bridge output (green lead wire)
E Shielded cable
«When input signals are directly hook up to the input connectors. »
● Wire the inputs using a four-pin shielded cable of minimal length.
● Keep the input cable as far as possible from power cables or other cables that are prone to
significant noise.
● When EDS-400A (or EDS-450A) is used at the place where vibrations are applied, use the
enough length of input cables and securely fix them, in order not to apply extra force to the
connected portion of the input cables.
NOTE
Strain gage type transducer
Strain gages (4-gage bridge)
R05-PB5M type connector bridge box(Optional accessory)
DB-120C-2R 120
Ω
,1 gage 2 wire type bridge box
DB-120C-3R 120
Ω
,1 gage 3 wire type bridge box
ＭＥＭ
Ｏ