KYMCO AHG1, Руководство по обслуживанию, Страница: 51 / 244

3. PERIODIC MAINTENANCE
3-18
Remove the reserve tank cap to add coolant
mixture until it reaches the F level mark.

Removing the cap while the engine
is hot that can cause the coolant to
spray out, seriously scalding you.
Always let the engine and radiator
cool down before removing the cap.

Using poor quality coolant may
shorten the service life of radiator.
Please be careful.

Use only low mineral drinking water
or distilled water for mixing cooling
liquid.
15.3. Coolant
recommendation
The owner must properly maintain the
coolant to prevent freezing, overheating,
and corrosion, use only high quality ethylene
glycol antifreeze containing corrosion
protection inhibitors specifically
recommended for use in aluminum engines.
(See antifreeze container label.)
Use only low-mineral drinking water or
distilled water as a part of the antifreeze
solution. Water that is high in mineral
content or salt may be harmful to the
aluminum engine.
Using coolant with silicate inhibitors may
cause premature wear of water pump seals
or blockage of radiator passages.
Using tap water may cause engine damage.
The factory provides a 50:50 solution of
antifreeze and distilled water in this scooter.
This coolant solution is recommended for
most operating temperatures and provides
good corrosion protection.
A higher concentration of antifreeze
decreases the cooling system performance
and is recommended only when additional
protection against freezing is needed. A
concentration of less than 40:60 (40%
antifreeze) will not provide proper corrosion
protection. During freezing temperatures,
check the cooling system frequently and add
higher concentrations of antifreeze (up to a
maximum of 60% antifreeze) if required.