28
B. PC Configuration
Connect PC and the gateway serial port (S1) by DB9 female cable to configure for PC. Run
“Modbus Slave”
software on PC. The
“Modbus Slave” parameters must be configured as shown in the following figure.
Connection: Serial Port
Mode: RTU
And then click
“OK” into the application page.
Now run
“Modbus Poll” on PC and set the parameters as shown in the following figure. Configure PC which
was connected to E1 to
192.168.0.249
. And then click
“OK” to enter the application page.
Finally, input numbers in address 1 and address 2 respectively in
“Modbus Slave”, the corresponding datas
Содержание KGW3101
Страница 1: ...KGW3101 Modbus Gateway User Manual 1st Edition August 2017 www kyland com...
Страница 4: ...5 1 Transparent A 27 5 2 Transparent B 29 5 3 Agent A 32 5 4 Agent B 35...
Страница 17: ...13...
Страница 30: ...26 5 Case Studies The following topics are covered in this chapter Transparent A Transparent B Agent A Agent B...