36
Then, click
“Serial Settings” in navigation bar to set the parameters of the serial port. At last, click the “Save”
to save the change.
Next click
“Agent Settings” in navigation bar and select “Gateway Settings” to set the parameters of the
device. At last, click the
“Save” to save the change.
Finally click
“Device List” in navigation bar and click “Add New Slave” to add a new slave device.
B. PC Configuration
Run
“Modbus Poll” software on PC. The “Modbus Poll” parameters should be configured as shown in the
following figure.
Connection: Serial Port
Mode: RTU
And then click
“OK” to enter the application page.
Содержание KGW3101
Страница 1: ...KGW3101 Modbus Gateway User Manual 1st Edition August 2017 www kyland com...
Страница 4: ...5 1 Transparent A 27 5 2 Transparent B 29 5 3 Agent A 32 5 4 Agent B 35...
Страница 17: ...13...
Страница 30: ...26 5 Case Studies The following topics are covered in this chapter Transparent A Transparent B Agent A Agent B...
