KWM Gutterman PANTHER, Эксплуатация и обслуживание

Страница: 24 / 37

SECTION 12
TOP # 8 DRIVE STATION AND BELL WHEEL ASSEMBLY
This is the last forming station in the machine. This station controls in and away from
the facia and drives the metal out of the machine. To much pressure will cause a twist
in the gutter not enough pressure will cause a ripple in the bottom of the gutter. The
factory settings for this station are, .030 gap from shoulder of the bottom #8, .020 back
side of the bottom and .007 to .015 on the front side of the bottom. The bell wheel gap
is .030.
ADJUSTING TOP #8 STATION.
This station is color coded white on face side and red on back side. To vertically adjust
this station, loosen locking bolt B two places, turn adjustment bolt A counter clockwise to
lower and clockwise to raise. To adjust laterally loosen set screw C two places witch will
allow roller to move laterally.(see pg. 23)
ADJUSTING BELL WHEEL.
To adjust bell wheel vertically loosen set screw D to allow movement of the roller. To
adjust laterally loosen locking bolt D, turn adjustment screw E clockwise to move away
and counter clockwise to move closer. The vertical setting is alignment of the top of the
bell wheel with the 9/16 bend. (see pg. 230)
– 22 –