KWM Gutterman PANTHER, Эксплуатация и обслуживание

Страница: 19 / 37

SECTION 10
STATIONS 1 THRU 7 FACTORY SETTINGS.
STATION #1 (BULLET ROLLER)
The bullet roller is factory set at .040 gap, in line with the bottom #1 and square over the
bottom #1. For further assistance contact your servicing distributor.
STATION #2 (HUB ROLLER)
The hub roller is factory set at .017 gap. The lateral setting is .900 from the inside of the
back keel rail to the out side edge of the roller and square to center line of bottom #2.
(see pg.10)
STATION #2 (FREE FLOATING TOP #2)*PANTHER III
The top #2 floater is factory set at double metal clearance.
Aligned over the bottom #2 floater. The roller is mounted on a eccentric shaft for
vertical adjustment.
STATION #3 AND #4
Top drive rollers are factory set at .017 gap. The lateral setting is .900 from the inside of
the back keel rail to outside of the top roller and square to center line of bottom #3 and
#4. (see pg.10)
STATION #6 AND #7 (SKATE ASSEMBLY)
The skate assembly is factory set at .027 gap. The lateral position is .040 from radius of
backside of the bottom #6 and #7 and square to center line of bottom rollers.
PRECAUTIONS:
The above factory setting should not be altered. A factory square is required in order to
square top rollers to bottom rollers.
– 17 –