KWM Gutterman PANTHER, Эксплуатация и обслуживание

Страница: 14 / 37

SECTION 7
Spool assembly and loading coil.
Spool assembly consists of:
(see pg. 13)
Fixed spool half.
Movable spool half.
1 5/16 spool bar.
5/16” Quick realease pin (movable side)
5/16” Bolt (fixed side)
Loading Coil
Remove spool from upright. With the spool on the ground or a flat surface remove
5/16” quick realease pin from the movable spool half. Remove the spool half from the
spool assembly. Insert the fixed spool half and the 1 5/16" spool bar thru the coil.
Reinstall movable spool half. Install 5/16” quick release pin.
DO NOT move the fixed half of the spool assembly. This half remains fixed to insure
alignment of the coil with the center line of the machine.
With the spool and coil assembled and ready for loading,
attach an approved lifting device to lifting hole. Before loading coil make sure spool
retaining pin is in the outward position and the fixed side of the spool is to the spool
retaining pin side of the upright.
P
RECAUTIONS
:
a. Never load coil with the spool retaining pin in the inward position.
b. Make sure loading area is clean and clear of debris.
c. Never operate machine without first checking spool retaining pins, pins must be in
the outward position.
D. Never transport machine without reinstalling spool retaining pins.
THESE PRECAUTIONS ARE FOR OPERATOR SAFETY AND TO PREVENT
DAMAGE TO YOUR MACHINE.
– 12 –