KVH Industries TracVision UHD7, Руководство по установке, Страница: 17 / 41

15
The steps for connecting the customer’s receiver(s)
to the TracVision system and setting them up
depends upon the customer’s satellite TV service.
Follow the steps in the applicable section below to
wire the receivers. Then connect the receiver(s) to
the customer’s television(s).
DIRECTV (SWM) Wiring . . . . . . . page 16
DISH Network/Bell TV Wiring . . page 19
NOTE: The DISH Network/Bell TV section includes
steps to connect most non-Wally DISH receivers. To
connect Wally receivers, refer to
“Using Wally
Receivers” on page 32 .
Figure 24: Receiver/DVR Wiring
Antenna
DISH Network and
Bell TV Receivers
Deck
TV-Hub
Antenna
POWER
TO SWM
AC Power
SWM Power
Inserter
DIRECTV U.S.
SWM Receivers
Note: The system does not support
DIRECTV non-SWM receivers.
Receiver
RF1 RF2
If you have any DISH/Bell receiver(s) other
than a Wally, during setup, you will need to
temporarily connect the receiver(s), one at a
time, directly to the “Receiver” port on the
TV-Hub and run a Check Switch test. Refer to
“Run a Check Switch Test” on page 30 or to
the Help for more details.
IMPORTANT!
Wire the Receivers
12