54-0274-01 Rev. C
7
© 2006 KVH Industries, Inc., All rights reserved.
1. Secure the antenna’s base to the mounting
surface using four
1
⁄
4
"-20 bolts,
5
⁄
8
" washers,
1" washers, and lock nuts, as shown in the
illustration. Be sure to insert the bolts from
above and use the supplied hardware for a
secure installation.
2. Tighten the bolts until the foam seal is fully
compressed and the antenna’s four rubber
feet are bottomed against the mounting
surface.
3. Reinstall the antenna radome.
The radome’s
“TracVision” labels should face fore and aft.
While pressing the radome down onto the
base, secure the radome to the base using
the three #10-32 screws you removed
earlier.
4. Install a protective plastic screw cap
(supplied in the kit)
over each radome screw.
Mount the Antenna
6
1/4"-20 x 3" Bolt
1/4" Flat Washer
(5/8" diameter)
Antenna Base
Foam Seal
Mounting Surface
1/4" Flat Washer
(1" diameter)
1/4"-20 Lock Nut
Insert the mounting bolts into
the antenna’s base from above,
not below.
Tighten Bolts
from Above
Antenna Mounted
