54-0274-01 Rev. C
4
© 2006 KVH Industries, Inc., All rights reserved.
1. Unfold the supplied template and
place it onto the mounting surface.
Make sure the “FWD” (forward)
arrow points toward the bow and
is parallel to the vessel’s centerline.
You do not need to mount the antenna
exactly on the vessel’s centerline, but
the antenna’s forward arrow must be
parallel to it.
2. Use the template to mark the four
hole locations on the mounting
surface.
3. Drill a
5
⁄
16
" (8 mm) hole at the four
locations you marked in Step 2.
Later, you will insert four
1
⁄
4
"-20 bolts
from above to secure the antenna to
the mounting surface.
4. Mark a location for the cable access
hole, either in the center of the
antenna mounting hole pattern or in
an area aft of the antenna.
Later, you
will route the antenna cable through
this hole and into the vessel.
5. Drill the cable access hole in the
location you marked in Step 4. Be
sure to size the hole appropriately
to maintain a cable bend radius of
at least 3" (75 mm).
If the hole location
is in the center of the antenna
mounting hole pattern, the diameter of
the cable access hole must not exceed
3.5" (88 mm).
Smooth the edges of
the hole to protect the cable.
Prepare the Mounting Site
3
15.5"
(39.4 cm)
2.8"
(7.1 cm)
5.6"
(14.2 cm)
4.6"
(11.7 cm)
9.2"
(23.4 cm)
4 x 0.31"
( 0.8 cm)
Mounting Holes
Cable Access Hole
(Suggested Location)
Antenna Base
X
Be sure the mounting surface is
flat and level. Use a separate
mounting plate, if necessary.
Drilling Antenna
Mounting Holes
