KVH Industries IP-MOBILECAST, Руководство по установке

Страница: 7 / 31

6
Follow these steps to install the Media Server.
Selecting a Location
Follow these installation guidelines:
• Select a cool, dry, and well-ventilated area
belowdecks away from any heat sources or
salt spray. Media Server temperature must
not exceed 50ºC (122ºF).
• Provide at least 3" (8 cm) of free space at the
front and rear to ensure proper airflow for
cooling.
• Leave plenty of room at the rear panel to
accommodate the cables with adequate
service loops and strain-relief.
Mounting the Media Server in a Rack
The Media Server can be mounted in a standard
equipment rack. You will need
1 U of available
space.
a. Remove all plastic film from the unit.
b. Be sure to support the bottom of the Media
Server – don't rely on the front mounting
brackets alone. The Media Server weighs
approximately 12.5 lbs (5.7 kg). If the rack
doesn’t already provide underside support,
install the four "L" rails provided in the kit
(see Figure 9). These rails can be nested for
extended depth; connect them end-to-end
using the supplied M5 screws and nuts (not
shown in the figure).
c. Insert the Media Server into the rack and
secure its front brackets (see Figure 10) to the
rack with appropriate fasteners.
Mounting the Media Server on a Shelf
a. Remove all plastic film from the unit.
b. Attach the adhesive-backed rubber feet
(supplied in the kit) to each corner of the
Media Server’s underside to protect the
mounting surface.
c. Secure the Media Server in some manner to
prevent it from shifting while the vessel is in
motion.
Figure 8: Media Server Dimensions
Front
Top
1.75"
(4.45 cm)
Rear
1.25"
(3.18 cm)
4 x 0. 40"
(1.02 cm)
4 x 0. 27"
(0.67 cm)
19.00"
(48.26 cm)
10.95"
(27.80 cm)
18.25"
(46.36 cm)
3.00" min.
(7.62 cm)
space
behind and
in front
Figure 9: “L” Rail Installation
Cage Nut (x4)
#6-32 Screw (x4)
“L” Rail (x2)
Left
Side Rail
Figure 10: Media Server Front Mounting Brackets
Front
Mounting Holes (x4) Mounting Bracket (x2)
Installing the Media Server
4