Kval MLX, Руководство по эксплуатации и обслуживанию

Страница: 84 / 144

Step 4: Calibrate the Face Tool
KVAL Operation Manual
3-20
Note: To help identify tools that need to be calibrated, view
Tool Path Review
. See
“About the Tool Path Preview Test Tab” on page 3-20
Tip: To help isolate tool function, use the
Tool Config
page to disable or enable sus
-
pected tools. After isolating the tool, run the
Door Job
. See “Routers: How to Iso
-
late and Calibrate a Specific Router” on page 3-21
1.
Create a new
Door Job
of a
Lock Cut
of your choice.
2.
Add
Door Job
to the
Queue
.
3.
Once the cut is machined, measure the
length
,
width
, and
depth
positions of the cut.
If the cut is not in the specification, determine which tool and axis needs to be cali
-
brated.
4.
Perform the
Left Hand Rule
pointed at the cut lock to determine axis direction. See
illustration below.
• If
diameters
of the plunges are out of specification, the
Diameter Offset
needs to
be adjusted.
• If the
length
of the cut is out of specification, the
X-Axis
needs to be adjusted.
• If the
width
of the cut is out of specification, the
Y-Axis
needs to be adjusted.
• If the
depth
cut is out of specification, the
Z-Axis
needs to be adjusted.
5.
If not in specification, adjust the location. Repeat until specification is reached.
Face Tools Calibration Reference Cut
The figure below, shows a sample reference cut and the type of offset to input into the calibration
menu. See “How to Enter Calibration Data” on page 3-7
+
X
+
Y
+
Z
-
X
-
Z
-
Y