Step 3: Calibrate the Edge Tools
KVAL Operation Manual
3-17
Edge Axis Calibration Reference Cut
The figure below, shows a sample reference cut and the type of offset to input into the calibration
menu.
See “How to Enter Calibration Data” on page 3-7.
Note:
To help isolate tool function, use the
Tool Config
page to disable or enable sus
-
pected tools. After isolating the tool, run the
Door Job
Isolate and Calibrate a Specific Router” on page 3-21
Process to Calibrate the Edge Tools
Note:
It is recommended to
verify the Tool Config
settings before calibrating the
plunge cut (
Z-Axis
). This is a global calibration. Therefore, by calibrating, other
tools may be out of calibration. For directions on how to use the configuration
See “About the Tool Config Tabs” on page 2-26
To help identify tools
that need to be calibrated, view
Tool Path Review
.
Preview Test Tab” on page 3-20.
1.
Create a
Door Job
of a
Edge
Lock Cut
of your choice.
2.
Add
Door Job
to the
Queue
.
3.
Once the cut is machined, measure the
length
,
width
, and
depth
positions of the cut.
If the cut is not in the specification, determine which tool and axis needs to be cali
-
brated.
4.
Perform the
Left Hand Rule
pointed at the cut lock to determine axis direction. See
illustration below and the next page.
• If
diameters
of the plunges are out of specification, the
Diameter Offset
needs to
be adjusted.
• If the
length
of the cut is out of specification, the
X-Axis
needs to be adjusted.
• If the
width
of the cut is out of specification, the
Y-Axis
needs to be adjusted.
• If the
depth
cut is out of specification, the
Z-Axis
needs to be adjusted.
5.
If not in specification, adjust the location. Repeat until specification is reached.
+
Z
-
Z
+
X
+
Y
-
X
-
Y
Содержание MLX
