Kval 990-H, Руководство по эксплуатации

Страница: 72 / 88

Lock Section Calibrations
See “How to Enter Calibration Data” on page 2-40 , for instructions to
enter calibration data.
Lock Locations:
Set the lock locations
for 3 standard door
lengths
To calibrate, run a
known good lock cut at
a standard location on
a Right Hand or Left
Hand door.
Once the lock cut is
completed, check the
distance from the top
of the door to the cen-
ter of the lock.
Note the measurement
value and compare to
specification.
Re run the calibration
routine until correct.
Face Bore Extend
Timers
:
This machine is
designed to bore a
lock with a three
stage bit.
This menu allows
you to set the bore
times of each stage.
(Shallow, Mid and
Deep)
Face Plate Timers
Vertical:
The amount of time, in seconds, to
give the vertical movement of the lock plate
when in “Fast Plate” or “Slow Plate” mode.
Horizontal:
The amount of time, in seconds, to
give the horizontal movement of the lock plate
when in “Fast Plate” or “Slow Plate” mode.
Single Step Disable/Enable Button:
Disable
the
Single Step
button to use the three stages.
Enable
the
Single Step
button to by pass the
three stages and perform the bore with one sin-
gle cut.
Lock Loca-
tion Measure-
ments
Note : Before adjusting
the Slow Lock Plate
Timing, make sure the
Fast Plate Routine is set
properly adjusted.
Setup Screen
2-43
KVAL 990-H Operation Manual