Kval 990-H, Руководство по эксплуатации

Страница: 32 / 88

Machine Components.
2-3
KVAL 990-H Operation Manual
Machine Components.
Components Descriptions
Electrical Panels There are two electrical boxes, located near the back section
of the machine
Operator’s Station The operator’s station houses the 990-H touchscreen and
other operational control switches. Note: On some options
the touchscreen includes operation or other machines in the
line, such as a feeder and stacker.
Door Clamp The door clamp secures the door to hold it in place as rout-
ing and drilling occur.
Door Stop The door stop sets the door in the correct position during in-
feed.
Jamb Stop The jamb stop acts as a jamb placement guide when jamb is
being loaded
Door Clamp Pedal The door clamp pedal is a foot pedal that, when pressed,
activates the door clamp to either clamp or unclamp the
door.
Jamb Clamp Pedal The jamb clamp pedal is a foot pedal that, when pressed,
activates the jamb clamps to clamp the jamb in place.
Routers Routers are located in on the lower front section to rout for
hinges, as well as a router on the back section to rout for the
faceplate
Six-Shooters The Six-Shooters are housed in the four movable heads on
the upper front section of the machine. The Six-Shooters
apply the screws to secure hinges to the door and jamb
Pre-drills The pre-drills are located in the Carriage Heads and pre-drill
the screw holes for hinge screw application.
Bolt Drill The bolt drill is located on the back section, and drills a hole
for the bolt.
Lock Bore The lock bore is located on the back section, and bores a
hole for the lock