Kval 990-H, Руководство по эксплуатации

Страница: 31 / 88

The 990-H Process Summary
KVAL 990-H Operation Manual
2-2
The 990-H Process Summary
The 990-H machines hinge pockets on both a door and a jamb and then attaches hinges to them.
While the hinge process takes place a door lock and face plate is drilled. Feeding the door to the
990-H, is an ON-2012 configured as a feeder. On the output is an ON-2012 configured as a
stacker. Figure
2- 2 on page 2- 4, shows locations of some key assemblies on the 990-H
• Cut a hinge pocket on a door and jamb (Carriage Assembly)
• Drill pilot holes for the hinge screws (Carriage Assembly)
• Apply hinges.(Six Shooter)
• Attach the hinges with screws (Six Shooter)
• Cut a lock and lock plate (Back Section)
Note:
Along with automatic control, manual control functions can be implemented. The machine
also accommodates mixed stacks and automatic door positioning with a two-speed feed belt sys-
tem.There is communication and timing of the door process between the 990-H feeder, and
stacker.
Machine Orientation
The
Front Section
refers to the side of the machine with the operator’s station, and includes the
three Six-Shooter heads, the front router motors, the pre-drills and chisels
The
Back Section
refers to side of the machine that routs the faceplate, bores the lock, and drills
for the bolt.
In-Feed:
The end of the machine (and its respective parts) that receives incoming doors
Out-Feed:
The end of the machine (and its respective parts) that feeds out the completed door
Typical Production Line Layout
The 990-H can be paired with different feeder and stacker model numbers. This manual assumes
the ON-2012 as a feeder and stacker. These machines are addressed in separate manuals.
ON-2012 Feeder
ON-2012 Stacker 990-H Door Hanger
FIGURE 2- 1.
The 990-H Door Hanging System