19
18
HOW TO DISASSEMBLE AND CLEAN
Turn the top-set counterclockwise and
lift off the base.
3
Quick Rinsing
* The products illustrated in this booklet may vary slightly from the actual product.
Switch OFF and unplug the power cord
from the wall outlet.
1
Note |
Extract all the remaining pulp in the
juicing bowl before stopping the juicer.
For easier clean up, operate the juicer for
an additional 30 seconds after the juice is
extracted.
When the drum lid is stuck, press the
REVERSE – OFF – FORWARD button in this
order, switching back and forth 2 to 3 times
to dislodge. Then place both hands on
the drum lid and firmly press down while
simultaneously turning the drum lid to open.
Fill the juicing bowl with water and run the
juicer before opening the drum lid. It may
help to open the drum lid when stuck.
·
·
·
Place the juicing bowl under running
water.
5
TIP |
The round brush can clean the juice
spout of the juicing bowl.
Turn the drum lid counterclockwise to
open.
2
Note |
When moving the appliance, do not lift
by grabbing the feed chute. Always lift
the appliance by grabbing the base or
handle.
Under running water, clean the outside of
the juicing screw with a dish scrubber. Use
the tip of the cleaning brush to push out
any residue in the crevices on the bottom
of the juicing screw.
6
Tip |
Note |
After juicing ingredients with seeds, make
sure to thoroughly clean the bottom
crevice of the juicing screw. (If this area
isn’t properly cleaned, it can cause the
part to be damaged).
Thoroughly clean the juicing screw
ensuring that the juicing screw is clean
without any residue.
Completely dry before using.
Clean the body with a soft damp towel
and dry.
7
Note |
If the towel is dripping wet, make sure
to squeeze out the excess liquid before
using it on the juicer.
With the juice cap closed, fill the juicing
bowl with water and turn on the juicer.
1
Let it run for about 1 minute. Open
the juice cap and let the water run
out of the juicing bowl.
2
Tip |
It is not necessary to completely clean
the juicer in between juices during a
single juicing session.
When finished with juicing, always
disassemble and clean thoroughly
between juicing sessions to prevent
residue buildup.
Remove the juicing screw, strainer and
rotation wiper unit from the juicing bowl.
Clean with provided brush.
4
Note |
Immediately clean the juicer after each
use. If remaining residue in the juicer dries
up, it can make disassembling and clean-
up difficult. The excess build up can cause
poor performance in future uses.
For easier disassembly, place the top-set
in the sink and run water through the top
of the top-set.
Thoroughly rinse the bottom of the
juicing screw.
*
EN
EN
