Kuppersbusch EKWE 320.S, Руководство по установке, Страница: 13 / 16

Installation instructions - EKWE/EKWH - USA
13
Programming the control honeycomb in
accordance with the cooking zone layout
Since the control honeycombs can be used for any kind of honeycomb layout,
the control honeycomb has to be informed on which cooking zones have
actually been installed and on the final layout.
Activating the programming function
– If necessary, the power supply must be cut off for a short time and then
resumed since the programming function is only accessible after a power
cut.
– Please wait until “circling zeroes” are indicated.
– Touch the clock and the minus sensor of the minute minder
simultaneously for approx. 5 seconds.
“C o d” will appear in the cooking zone displays, and the display of the minute
minder will indicate “0”.
– Set “88” with the plus and minus sensors of the minute minder.
– Touch the minute minder clock sensor.
An acoustic signal will sound as confirmation.
Now all available plus and minus sensors will light up and the dual-zone
sensors will flash. “0” is indicated in the LED displays.
Indicating the honeycomb layout and type of honeycombs
– Test by touching one of the plus sensors which have lit up.
The respective hexagonal surrounding of the plus sensor is activated.
– Touch the minus sensor in this hexagonal surrounding.
The hexagonal surrounding is switched off again. Switching on and off in this
manner can be repeated as often as required with any of the surroundings.
– Now show the installation layout of the honeycomb cooking zones by
activating the respective hexagonal surroundings on the control
honeycomb.
The position of the control honeycomb may not be shown.
– Where dual-circuit honeycombs have been installed, the dual-circuit
sensor must also be touched. The symbol now lights up constantly.
Prior to commencing to the next step, check to ensure that
• the hexagonal surroundings indicated on the control honeycomb fully
comply with the installation layout of the honeycomb cooking zones .
• the dual-circuit symbol lights up constantly where dual-circuit cooking
zones have been installed.
• the dual-circuit symbol flashes where single-circuit cooking zones have
been installed.
Allocating the pan-on detection to the cooking zones
No pans or any other metal objects may be located on the cooking zone
when carrying out the following step since this could result in problems
with the pan-on detection.
– Touch the key sensor to confirm the layout of the cooking zones which
has been set.
Now one of the honeycomb touch controls on the control honeycomb will start
to flash.