Kuppersberg WD 1488, Технический паспорт

Страница: 15 / 64

15
ENGLISH TECHNICAL PASSPORT
Washing Dryer Machines
PROGRAMME selector with OFF
position
When the programme selector is
turned the display lights up to show the
settings for the programme selected.
For energy saving, at the end of the
cycle or with an inactivity period, the
display level contrast will decrease.
N.B.: To switch the machine off, turn the
programme selector to the OFF position.

Press the START/PAUSE button to
start the selected cycle.

Once a programme is selected
the programme selector remains
stationary on the selected programme
till cycle ends.

«End» will appear in the display
at the end of the program and the
DOOR LOCKED light will go off, it is now
possible to open the door.

Switch off the washing machine
by turning the selector to OFF.
The programme selector must be
returned to the OFF position at the
end of each cycle or when starting a
subsequent wash cycle prior to the next
programme being selected and started.
START/PAUSE button
Close the door BEFORE selecting the
button START/PAUSE.

Press to start the selected cycle.
When the START/PAUSE button has
been pressed, the appliance can take
few seconds before it starts working.
ADD OR REMOVE ITEMS
AFTER THE PROGRAMMES HAS
STARTED (PAUSE)

Press and hold the START/PAUSE
button for about 2 seconds (some
indicator light and the time remaining
indicator will fl ash, showing that the
machine has been paused).

Wait until the DOOR LOCKED
light has gone out before opening the
door.
Before you open the door, please check
water level is below the door opening
to avoid fl ooding.

After you have added or removed
items, close the door and press the
START/PAUSE button (the programme
will start from where it left off).
CANCELLING THE PROGRAMME

To cancel the programme, set the
selector to the OFF position.

Wait 2 minutes until the safety
device unlocks the door.
DELAY START button

This button allows you to pre-
programme the wash cycle to delay the
start of the cycle for up to 24 hours.

To delay the start use the
following procedure:
 Select the required
programme.

Press the delay start button
once to activate it (h00 appears on
the display) and then press it again to
set a 1 hour delay (h01 appears on the
display). The pre-set delay increases by
1 hour each time the button is pressed,