50
Use at the field
Start position
mode
The loading arm and the table must be put into start position before
wrapping can get started.
The start position is reached when:
•
the loading arm is in the middle position
•
the table is fully downwards and in the loading position
Joystick control
> Push the joystick right and hold it to lower the loading arm to the
middle position
> Push the FJ button to move the table in the loading position
Electronic control
> Push to move the loading arm in the middle position and to move
the table in the loading position
The table revolution counter will be reset now.
Wrapping
The wrapping cycle depends on the kind of control on the machine:
•
cable control
•
joystick control
•
electronic control
Cable control
> Drive to the bale
> Move the right lever forwards to lift the bale using the loading arm
onto the table
> Move the right lever backwards to lower the loading arm
completely
> Hold the middle lever for 1 revelation to start wrapping
The table must turn with maximum 30 rpm.
After the last but one number of film wraps, the buzzer sounds. Than
the final wrap is added.
Extra wraps can be added. The buzzer will sound 2 seconds for every
extra wrap.
> Leave the middle lever to stop wrapping
The bale counter will be reset to zero.
The table must be in tip off position now.
> Move the left lever backwards to unload the bale
With hydraulic bale turner [+]
> use the concerning hydraulic tractor valve
> Push the joystick forward to move the table forwards
> Push the FJ button to move the table into loading position
Left lever
Right lever
