KUHN GMD 801, Руководство по сборке и эксплуатации

Страница: 32 / 48

- 30 -
CHANGING GEARBOX OIL
Check gearbox oil level daily. Top up with SHELL
SPIRAX SAE 80 W EP (GL4) oil if necessary by filling
up through plug (B) (photo 44).
MAXIMUM AMOUNT OF OIL IN GEARBOX :
1 l / 2 US pint / 1.75 Imp pint
NEVER EXCEED THIS QUANTITY.
Check oil level through plug (C) (photo 44) when the
cutterbar is horizontal to the ground. Oil level is correct
when oil reaches the edge of the hole. When the
cutterbar is in the vertical position, oil can be drained
through plug (C).
P.T.O. SHAFTS
Lubricate all PTO shafts with SHELL Multi-Purpose
grease NLGI grade 2 at the hourly intervals indicated in
the fig. opposite.
GREASE FITTING
- Clean fittings before applying grease.
- Grease breakaway sliding components as required.
- Regularly lubricate 3-point frame pivot (E)
(photo 46)
- After every 50 hours of operation, oil all moving parts
and pivot points.
THE RECOMMENDED GREASE AND OIL CHANGE PERIODS ARE BASED ON NORMAL
FIELD AND WORK CONDITIONS.
SEVERE OR UNUSUAL CONDITIONS MAY REQUIRE MORE FREQUENT LUBRICATION
OR OIL CHANGES.
RESPECT SPECIFIED OIL QUANTITIES AND GRADES : SHELL SPIRAX SAE 80 W EP (GL4)
OIL ONLY.
(In certain countries SHELL SPIRAX SAE 80 W EP (GL4) oil may not be available. In this case a GL4 or GL5 grade
SAE 80 W 90 oil is an acceptable substitute. Never use a straight EP 90 oil in the cutterbar).
All manuals and user guides at all-guides.com