KUHN GMD 801, Руководство по сборке и эксплуатации

Страница: 17 / 48

- 15 -
8° Assembling safety curtain and outer safety guard
- Pre-assemble the safety curtain (1). To do this attach clamp collars (2) to curtain (1) and loosely fasten rod (3)
with these clamp collars (photo 3).
- Attach both hinges (6) with cup square bolts (7) (M 10 x 20) (photo 3 and figure 5).
- Install cover (1) as shown in photo 3. Buckle straps around the pipe frame at (8).
- Buckle straps (5) around front and rear safety bar.
- All these straps are attached underneath the safety cover (photo 4).
- Punch 3 holes in the safety cover at (10) and attach
cover on the outside arms of the safety bars with
round head screw (R) (M 10 x 30) of stop rod (J), 2
round head screws (U) (M 10 x 35) of outer safety
guard (S), 1 plastic washer (T) (dia. 10.5 x 32 x 2.5)
and 3 self-locking nuts (O) (M 10) (fig. 1 and photo
4).
- At (9) attach the outer safety guard (S) to the front
guard flap tube using a round head bolt (C) (M 10 x
50) and a self-locking nut (O) (M 10) (fig. 1 and photo
4).
- Attach springs (16 and 17) to their respective
anchorage points with the small chains (photos 3, 6
and fig. 5) and close the eyelets .
9° Attaching break-away latch
Connect the break-away latch (34) to the yoke of
3-point frame (30) with axle (31), 2 roll pins (32) (dia.
6 x 36) and a plain washer (33) (dia. 23 x 40 x 7) as shown
in photo 6.
All manuals and user guides at all-guides.com