KUHN GMD 801, Руководство по сборке и эксплуатации

Страница: 29 / 48

- 27 -
OPERATING THE MOWER
GENERAL
Before engaging the machine into the grass, lower the cutterbar to the ground and bring the PTO shaft up to its
nominal speed (rotational frequency) [1000 rpm (min
-1
) ].
Do not allow the PTO to drop to too low a speed (rotational frequency) as this would reduce cutting quality.
Forward speed should be determined in accordance with work conditions.
We recommend that forward speed be reduced when working in high density crops or in difficult conditions.
Check that covers (14-15) (photos 51 and 51 A, page 33) of inner and outer cones are securely attached. Replace
immediately if worn or damaged.
BEFORE STARTING WORK BRING THE GUARD DOWN INTO THE CORRECT POSITION.
FASTEN THE SAFETY CURTAINS USING THE STRAPS PROVIDED.
DO NOT STAND ON OR LEAN AGAINST THE GUARD.
BEFORE BEGINNING WORK, KEEP ALL PEOPLE AND ANIMALS AWAY FROM THE
DANGER ZONE OF THE MACHINE (RISK OF PROJECTION).
ADVERSE FIELD CONDITIONS
NEVER MOW IN STONY OR ROCKY GROUNDS.
Extra care and precautions should be taken in rough or debris-ridden fields. The following adjustments should be
made to the mower in these conditions to minimize the possibility of foreign objects being deflected by the cutting
knives.
1° Tilt the angle of the cutterbar back towards the horizontal position by turning the top link handle (P) (photo 25,
page 22) to raise the cutting height of the knives.
2° Reduce the forward speed.
3° Make sure the cutting knives can pivot if an obstruction is hit.
NEVER OPERATE THE MOWER WITHOUT THE PLASTIC COVER IN PLACE. DO NOT LEAN
AGAINST OR STAND ON THE GUARD COVER.
All manuals and user guides at all-guides.com