KUHN GMD 801, Руководство по сборке и эксплуатации

Страница: 30 / 48

- 28 -
LUBRICATION
It is forbidden to discard oil, grease or filters of any type. These must be given to specialised
waste disposal organisations to protect the environment.
IMPORTANT !
After the first 10 hours of use imperatively change oil SAE 80 W EP (GL4) in : - cutterbar
- rotor gearbox.
Thereafter, oil must be changed after every 200 hours of work and at least once per year.
BEFORE CARRYING OUT ANY OPERATION SUCH AS MAINTENANCE OR ADJUSTMENT
ON THE MACHINE, STOP THE TRACTOR ENGINE, REMOVE IGNITION KEY AND WAIT
FOR ROTATING DISCS AND ROTOR TO STOP BEFORE LEAVING THE TRACTOR.
CHANGING CUTTERBAR OIL
Before changing the oil of the cutterbar, let the machine
run a few minutes so the oil gets hot.
Proceed as follows to change the cutterbar oil :
1° Lift the cutterbar into its vertical position by
means of the hydraulic cylinders (photo 42).
2° Remove inner shoe (18) of main gearcase (photo
42).
3° Remove magnetic oil plug and its washer (19, 20)
(photo 42 and fig. 43A) and let the old oil drain out
into an appropriate container.
4° Remove inner plug (21) (fig. 43).
5° Clean magnetic plug and its washer (19, 20) and fit
back into place once dripping has stopped.
6° Fit inner shoe (18) back into place.
7° Lower the cutterbar so that it is horizontal to the
ground and pour the quantity of fresh oil prescribed
below into one of the fill plug holes (21) (fig. 43).
8° Clean inner plug (21) and its washer (22) and fit
back into place (fig. 43).
QUANTITY OF OIL IN CUTTERBAR
2.25 l / 4.5 US pint / 4 Imp pint
All manuals and user guides at all-guides.com