KUHN GMD 55, Руководство по сборке и эксплуатации

Страница: 19 / 44

- 17 -
- Install cover (D) as shown in photo 17. Buckle straps around the pipe frame at "E".
Buckle straps (F) around front and rear safety bar.
All these straps are attached to the underneath of the safety cover.
- Punch 3 holes in the safety cover at "G" and use 2 cup square bolts (R) (M 10 x 35) and 1 cup square bolt
(V) (M 10 x 50) with self-locking nuts (O) (M 10) (fig. 15, photos 17 and 18) and plain washers (Q) (dia. 11 x
24 x 2) to attach the following components on the outside arms of the safety bars : safety guard locking device
(S) ; safety cover (D) ; stop rod (J) on GMD 44 and 55 SELECT (fig. 15).
Note : Make sure that the pivot axis of the safety guard locking device (S) is lined up with the pivot axis
(N) of the front safety bar before tightening self-locking nuts (O).
CAUTION : ALWAYS OPERATE MOWER WITH SAFETY COVER IN PLACE AND THE
FRONT END OF THE COVER LOWERED. NEVER LEAN AGAINST OR STAND ON
SAFETY COVER.
- The safety guard locking device is operated with an
16 mm box spanner (T) to be stored in the support
(U) provided (photo 19).