KUHN GMD 55, Руководство по сборке и эксплуатации

Страница: 36 / 44

- 34 -
SWATH BOARD
(photos 56 and 57)
A narrower swath width can be achieved on GMD 55
GMD 66 SELECT multidisc mowers by fitting an inner
swathboard assembly. This will bring the swath width
down to about 1.07 m (3'6") on the GMD 55 SELECT
and 1.50 m (4'11") on the GMD 66 SELECT ,
depending on crop density.
A further reduction in swath width can be obtained
by fitting, in addition, the longer outer swathboard
which will reduce the width down to about 0.90 m
(2'11") on the GMD 55 SELECT and 1.30 m (4'3")
on the GMD 66 SELECT , depending on crop density.
Kit No. 103 6010.
DISC WITH CONE
(photo 58)
(Kit no 104 6050 for GMD 55 SELECT )
In order to reduce swath width on the GMD 55
SELECT , the first disc or the first and second discs
can be replaced by one to two discs with cones (photo
58).
When replacing disc, tighten correctly self-locking nut
(Q) (fig. 45) : 1 8 daNm / 130 ft.lbs.
SIGNALLING ELEMENTS
(photo 59)
(Kit no 102 6100)
Signalling elements can be ordered as an optional
extra. To install this kit proceed as follows :
- Attach tail lamp (N) to panel (A).
- Bolt panel (A) to support (S) with 3 hexagon screws
(E) (M 10 x 20), 3 plain washers (dia. 11 x 24 x 2)
and 3 self-locking nuts (M 10).
- Attach guide (H) to the rear guard tube (T) with an
U-bolt and 2 self-locking nuts (L) (M 10).
- Plug electric cable (O) into the lamp terminal (N).
In transport position mount the panel (A) with its
support (S) in the guide (H) with lock (U) and plug
electric cable at the rear of the tractor.
Before putting the machine in
work position, dont forget to
unbolt the panel.